Apuntes

E LIMINAR PASS ENABLE (MANTENIENDO CONFIGURACION ) - CISCO 2960  Fuente: http://www.cahilig.net/2014/04/14/how-reset-cisco-2960-switch-password-without-losing-your-configuration To  reset  your  Cisco  2960  password , connect your console cable to the switch and open up your terminal emulator software, you can use minicom if you are using Linux. Please visit this  link  on how to  install  and configure minicom using in Fedora/Red Hat/ CentOS  and this  link  if you are using Debian/Ubuntu. Power on the switch while holding the mode button. Release the mode button after you see the screen below in your terminal emulator software. Boot Sector Filesystem (bs) installed, fsid: 2 Base ethernet MAC Address: 1c:1d:86:db:c8:80 Xmodem file system is available. The password-recovery mechanism is enabled. The system has been interrupted prior to initializing the flash filesystem. The following comma...